- Détails de l'article
Facile à utiliser
- Repassez confortablement sans être gêné par le fil.
- Le guide fil est facilement replié en ‘soulevant’ ‘l’antenne’ du support.
- Notez : le guide fil convient à toutes les tables à repasser Brabantia à l’exception de la Table à repasser Steam Control.
Guide-Fil - Dark Grey est évalué de 5 de 14.Rated 5 de 5 de cannylad par Long Awaited Facility My ironing board is very old - the flex guide ditto -held on by spring clip . The new attachment which remains on the board is stronger, more flexible and easier to use. An excellent product,well made and delivered promptly tooDate de publication: 2015-06-25Rated 2 de 5 de grandma A par Not impressed I bought a new brabantia ironing board and could not get my old flex holder to fit the new board , so ordered this one. It was easy to attach to the board but the flex on my iron was too thick to slot into the holder and the guide itself is so high I had to move furniture out of the way for the flex to reach the plug. In the end I bought a longer flex for my iron - cost nearly another £7.00 - and even though it is thinner than the original it still does not slot cleanly into the flex holder. Also, because you have to take the flex out of the holder to store the ironing board away it is fiddly to find the correct length every time and I fear that over time, having to take the flex in and out will cause the flex to become threadbare and need replacing. If I can find an alternative I will not hesitate to buy one.Date de publication: 2017-06-01Rated 2 de 5 de AlanB par Nothing special Sort of does the job ok, but is always in the way - either while vertical or in the storage position. Should fit under the edge of the board. But does help keep the flex out of the way while in use. Just gets in the way of the iron a bit during use and is a nuisance while the board is stored. Also because the fixing clamp is plastic it is difficult to keep it tight - I'm frightened it's going to break if I do it up any more as it's bowing out as it is.Date de publication: 2017-09-21Rated 1 de 5 de mh1040 par Pas du tout adapté aux fils plats des centrales va Le Guide-fil est pensé pour des fils ronds, si votre centrale vapaur a un fil plat il ne tient pas ds le guide-fil, saute en permanence et rend le repassage impossible. Je dois dire que je l'ai rangé, ne l'utilise pas et vais continuer à chercher un guide-fil approprié.Date de publication: 2017-01-13Rated 2 de 5 de CS13 par Does not hold the Cord I bought this to hold the Cord of my Steam Generator Iron but it does not hold the cord for more than a few minutes as the clip is not wide enough to hold the cord properly even though the picture on the advert shows the same type of Iron I haveDate de publication: 2016-11-08Rated 5 de 5 de Granny78 par Great reach range and easy to fold away. I can't imagine why anybody who has ironingmto do wouldn't want this product. In my opinion there's nothing worse than having the flex trailing over the surface of the article on the board.Date de publication: 2016-08-05Rated 4 de 5 de Alan holt par replacement for old brabrantia flex guide I replaced my flex guide after after being very happy with it for about four years but was disappointed when the thread seized taking it off to transfer onto new board. suspect dodgy threadDate de publication: 2015-12-17Rated 1 de 5 de Nicelo par Pas super !!! Le câble du fer à repasser ne tient absolument pas dans la pince prévue à cet effet. Gardé et utilisé après une modification effectuée par mon mari, il a remplacé la pince pour le câble.Date de publication: 2017-10-17